60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels

You looking to find the "60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels" Good news! You can purchase 60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

   

Product Feature

• 60 Amp Solid State Pulse Width Modulation Charge Controller
• High Contrast Volt Meter
• Microprocessor controlled for stability and functionality
• Fully wired, ready to go for both wind and solar
• Works directly with 12 and 24 volt systems

Product Description

Some of the key features of this controller are:

� Microprocessor controlled.
��Solid-State. No relays or solenoids to wear out.
� Pulse Width Modulation charging (Charges using pulses of varying lengths)
� Three stage charging for better battery life.
� Both manual and automatic (30 day) equalize function.
� �User changeable settings!</br>◦High Amp rating - 60 Amps solar mode or 60 Amps in the diversion mode.
◦Over-current, over-voltage and overheat protection.
◦Multiple system voltage settings
� High Contrast LED battery voltage meter.� On/Off switch for the meters to allow extremely low idle current.
Battery and charge status LEDs
��Push to test
� Reverse polarity protected - This unit will not be damaged if you inadvertently reverse the inputs.
� Steel enclosure - with multiple conduit openings and cooling vents
� Large terminals - that can actually terminate large wire, with lugs that accept up to #2 wire.
� �Extended diversion mode (EDM.)
� Works as either a solar charge controller (series), or a diversion controller for � wind/hydro systems. The controller will automatically sense the appropriate mode.
� Passive cooling systems uses aluminum cooling pipes that run the length of the unit for continuous cooling of the entire unit allowing for proper operation at high power levels.
� No blocking diodes are required for solar. The back-to-back mosfets prevent reverse leakage.
◦A PWM controller that adapts its pulse logic to perfectly accommodate wind systems.
� Note: Continuous power handling will be reduced in hot climates or installations.

60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels Review

Was a breeze to install and hookup, replaced an old unit which was damaged during an electrical storm.
do yourself a favor and ground your battery banks, solar panels, and all neutrals in your elec system to
earth ground in case of a lightning strike. this will possibly save a voltage spike from taking out your equip.
(speaking from experience).

Most of the consumer Reviews tell that the "60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels" are high quality item. You can read each testimony from consumers to find out cons and pros from 60 Amp Solid State PWM Charge Controller for Wind Turbine Generators and Solar Panels ...